Student Work
Development of high performance materials used in the fabrication & assembly of electronic hardware
PublicAn experiment was conducted on printed circuit board parameters with regards to the 0201 surface mounted component (.020 x .010 inches) and the defects affecting them by varying four of the process parameters. Although some of the alternative products performed just as well as those presently used by MIT Lincoln Laboratory; from a business standpoint it was recommended that the process parameters used by the laboratory remain the same; .005 inch laser cut stencil, SC3401 solder paste, and the RSS (1088) profile.
- This report represents the work of one or more WPI undergraduate students submitted to the faculty as evidence of completion of a degree requirement. WPI routinely publishes these reports on its website without editorial or peer review.
- Creator
- Publisher
- Identifier
- 05C030M
- Advisor
- Year
- 2005
- Center
- Sponsor
- Date created
- 2005-01-01
- Resource type
- Major
- Rights statement
Relations
- In Collection:
Items
Permanent link to this page: https://digital.wpi.edu/show/t435gh025