Student Work
Loudspeaker frequency response correction using digital signal processing
ÖffentlichThe purpose of this project was to design a DSP based loudspeaker correction processor. To accomplish this task, we measured the frequency response of loudspeakers and used MATLAB to design correction filters that would correct the response within a +/- 1dB tolerance from 200Hz to 20kHz. We then implemented the filters to the DSP evaluation board. Frequency response measurements and blind listening tests were used to judge the effectiveness of our design.
- This report represents the work of one or more WPI undergraduate students submitted to the faculty as evidence of completion of a degree requirement. WPI routinely publishes these reports on its website without editorial or peer review.
- Creator
- Publisher
- Identifier
- 01B035M
- Advisor
- Year
- 2002
- Date created
- 2002-01-01
- Resource type
- Major
- Rights statement
Beziehungen
- In Collection:
Objekte
Permanent link to this page: https://digital.wpi.edu/show/6w924f83b